How To Change Xbox Buttons

Introduction

This guide will teach you how to remove the buttons.

• Remove the battery pack cover.

• Remove batteries.







• Nosotros recommend using a nylon spudger for this pace. A metallic spudger is shown.

• Grip the controller firmly to remove the side handles, wedging a spudger into the seam between the front and handle plates.

• Pry the side plate abroad from the front end plate by moving the spudger dorsum and forth. You will need to do this all the way effectually the side plate'south seam.

• In that location is a hidden screw located in the middle of the controller backside the label.

• Use a screwdriver and dial a hole directly in the center of the characterization.

• You may too lift the label if you practise not want to puncture it.

• Remove the five 10mm screws located on the back of the controller using the T8 Security Torx Screwdriver.

• Remove the backplate.

• Remove the faceplate.

• You may let the rumble motors hang freely out of their sockets.

• De-solder the soldered joints while holding the red and black wires downward on the elevation motherboard.

• De-solder the blackness and gray wires that are attached to the meridian motherboard.

• Remove the rumble motors and set them bated.

• Be careful while using the soldering iron not to damage other components or hurt yourself.

• For data on how to solder, click here.

• Unscrew the ii 7mm T6 screws located near the rumble motor sockets.

• Firmly grip sides of motherboard near the middle.

• Lift up while slightly wiggling the motherboard forward and backward.

• Lifting the motherboard will require some forcefulness.

• Remove the six T6 Torx screws located on the lesser motherboard.

• Remove the bumpers past prying them off of the pegs that secure them, using a spudger. They are located on the front and dorsum of the controller.

• A standard nylon spudger is recommended for this step. Using a metal spudger near the motherboard as shown risks damaging your device.

• Elevator the piece surrounding the Home button off of its pegs.

• Pry it off of the other side, using a spudger on the pins.

• A standard nylon spudger is recommended for this step. Using a metal spudger well-nigh the motherboard as shown risks damaging your device.

• Removing this piece may require a lot of force.

• Remove the bottom motherboard.

• Remove the rubber bankroll to the buttons.

• With the buttons facing down, push them up out of their housings, and remove.

Conclusion

To reassemble your device, follow these instructions in opposite order.

Team

Embed this guide

Cull a size and re-create the lawmaking below to embed this guide every bit a small widget on your site / forum.

Preview

How To Change Xbox Buttons,

Source: https://www.ifixit.com/Guide/Xbox+One+Wireless+Controller+Buttons+Replacement/36845

Posted by: fergusonwhiseved.blogspot.com

Share this post